I now dry the water from the fold after each wash but still have a build up of black mould spots.
Clean mould washing machine door seal.
Make sure to wipe underneath and around it as well.
How to clean door gasket on front loader washer.
Clean the washing machine dispenser drawer.
After cleaning the rubber seal in your washing machine take care to allow the area to dry thoroughly between each wash to prevent further mould mildew or odour build up.
Carry out regular cleaning of door and seal.
It might seem counterintuitive but the best way to prevent mold on a washing machine seal is to leave the door open.
Clorox bleach gel works best https amzn to 30l26zh how to remove mold from the washing machine rubber gasket using baking soda clorox bleach vinegar h.
Cleaning a washing machine door seal not only can bad smells come from the washing machine drum they can also accumulate in the rubber door seal.
If you can leave the washing machine door open.
In fact if you wanted to carry out the ultimate washing machine maintenance schedule that would prevent mould build up and smells you could try the following steps on a monthly basis.
Particularly on older front loaders.
How to clean mold off the rubber seal on a front load washer.
Clean the door seal.
Typical front loader washing machine with its door slightly open to minimize mold and mildew growth on the rubber seal.
This allows the inside of the machine including the gasket to dry quickly.
How to prevent mold on a washing machine seal.
The machine and laundry have an odor from the mould.
As a result there usually isn t enough moisture on the gasket to allow mold to grow.
Clean the door seal and surrounding area.
Hard to clean the rubber door seal gasket because hard to remove all the stubborn mold and mildew without damaging the door seal.
To properly remove mold growth from your washing machine you need to clean every part of the washer where mold might grow.
Be prepared for some slime and gunk and possibly a stray sock or two.
This mould has built up over time in the fold in the rubber seal on the door.
Use a rag or towel to clean the rubber door gasket on a front loading washer with either hot soapy water or a spritz of mildew cleaner.
Cleaning gasket on washer.
Start with the gasket that seals the door as this is an area that is often forgotten and tends to attract a lot of mold growth.