Face Nailing Siding

These butt joints should be staggered to avoid noticeable patterns which is determined by the placement of the first course.

Face nailing siding.

Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation. The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going. Face nailing exposes the fastener head to the elements and allows for the fastener to penetrate through two sheets of overlapped. These nails tend to be.

Siding is installed with slight overlap between boards a bit like the way shingles are installed. The walls are brick veneer but the top triangular gables are hardi siding i live in victoria texas. Renail the siding keeping the new nail in the center of the nailing slot and leaving it about 1 16 in. Center joints over studs unless special metal off stud joiners are.

In face nailing a nail is driven through the face of the board driving down through two overlapping layers into the substrate below. What are face nails. Next nail the first row of siding into the studs leaving 1 8 gaps at the corner boards to allow for caulking. Loose siding can leave your home unprotected from weather and insects.

Siding nail face nailing face nailing is applicable where dictated by building code in high wind areas and when fastening is to osb or equivalent sheathing without penetrating into studs. Hardieplank is fastened to the home by either blind nailing or face nailing. Lift the siding up and look for nails that have been hammered in too tightly. I have been reading all the dialogue about face nailing hardi plank siding etc.

Nails do not need to be predrilled except near the ends. Loosen the tight nail or cut it with a hacksaw. Blind nailing is preferable to face nailing since any nail heads are hidden by the next row of siding. Up off the siding.

The nails are covered by the board overlap in the blind nailing method while the nails are left exposed on the exterior of the boards in the face nailing method.